Appendix C Usb Call Recording; Usb Call Recording - NEC UNIVERGE SV9500 User Manual

APPENDIX C

USB CALL RECORDING

You can record the voice call data to a USB memory,
the recorded voice call data can be played later. When
the call is being recorded or when a recording error
occurs, the status is indicated as an icon on the LCD of
the terminal.
When the recording starts, the recording confirmation
tone will be sent to the target party at an interval of 15
seconds. However, the recording confirmation tone can
also be disabled. For the recording data, a tone of
recording start is saved in the USB memory to check
the timing of recording start (or restart from a recording
pause) while the recorded voice is played.
For using this feature, the following system software
version and terminal firmware version are required.
Note
- SV9500 V2 or later
- Terminal firmware version 3.0.0.0 or later
For format types of USB memory, be sure to use a USB
memory (USB 2.0 or later) which has been formatted as
Note
FAT or FAT32. Other USB devices (hard disk with USB
connector or card reader with USB connector etc.) are
not available.
The maximum recordable time depends on the storage
Note
capacity of the recording area.
USB CALL RECORDING
224
NEC recommends a capacity of the recording area of
more than 200 MB (50 minutes recordable by linea
PCM (16kHz)), and a maximum memory size of record-
Note
ing data of 4G (when you format the USB memory with
FAT32)/1G (when you format the USB memory with
FAT).
Note
Up to 3999 recording files can be saved.
Be sure not to remove the USB device while the tele-
phone conversation is being recorded or played back. It
Note
may cause corruption of the USB memory or recorded
files.
• STATUS ICONS AND LED DISPLAY
[DT830G(24CG)]
USB
Ken Kobus
Mic NoDist
Status Icon
REC
00:05 7205
>>>