NEC UNIVERGE SV9500 User Manual page 226

• To pair Bluetooth
phone
DT830G and a mobile phone can be connected
through Bluetooth
adapter with the mobile phone.
For the terminal, a maximum of 8 pairing informa-
tions can be saved. However, the most recently
connected mobile phone is connected through

Bluetooth first.
STEP 1: Confirm that Bluetooth
nect key lamp turns off).
STEP 2: Hold down the Connect key for over eight
seconds to enable pairing mode (When the
Connect key has been kept pressed three or
more seconds, the Connect key lights red).
However, to enable pairing mode, continue to
press the Connect key until it lights alternate-
ly red and green.
STEP 3: The mobile phone scans for the Bluetooth
device, pairs itself with the Bluetooth
er, and connects to the terminal. For details
of this procedure, refer to the manual of your
mobile phone.
If the terminal is not operated for three and a half min-
Note
utes after terminal enters into pairing mode, the Blue-

tooth feature will be enabled.

adapter with mobile

by pairing the Bluetooth

feature is OFF (Con-
Note

• To enable Bluetooth
STEP 1: Press the Connect key several seconds (from
STEP 2: The Connect key lights red, and the Blue-
Note
Note
Note


adapt-
218
If the terminal and the mobile phone are already paired,
the terminal and the mobile phone can be connected

through Bluetooth only operating with the mobile
phone.

three or more seconds to less than eight sec-
onds) when the Bluetooth
(the Connect key is turn off).

tooth feature turns ON.
When the terminal starts up, the Bluetooth
be automatically ON.

When the Bluetooth feature is ON, the Bluetooth
connection is made with the most recently connected
mobile phone.
If you press the Connect key for eight seconds or more,
the terminal status will be Pairing mode (Flashing alter-
nately Red and Green every one second).
feature

feature is OFF

feature will
