Table of Contents
Advertisement
Accessories Check
This instrument works with standard and optional accessories.
Some accessories may differ than their representations shown in this manual.
Memo
Standard Accessories
White Calibration Plate CF-A24
Used to perform white calibration for measurement
of reflectance. A CD-ROM containing white
calibration data and software for writing the white
calibration data is supplied with this accessory.
White Calibration Adapter CF-A28
Used to calibrate the instrument's white
sensitivity for noncontact measurements.
Target Mask CF-A21, CF-A22, CF-A23
Used to match the illumination (specimen measuring
port) area to the specimen. The illumination and
measurement (specimen measuring port) areas are as
follows when the respective target masks are attached.
CF-A21
（MAV）
φ11 mm
Illumination area
Measurement area φ8 mm
Two screws are included with the target mask
Memo
for securing it to the instrument.
Zero Calibration Box CM-A155
Used to perform zero calibration for measurement of reflectance.
AC Adapter AC-A308
Used to supply power from an AC outlet to the CF-300.
Input: 100 to 240 V
50/60 Hz 0.25-0.16 A
Output: 8 V
1.5 A
Plug design:
Center-negative
USB Cable (2 m) IF-A19
Used to connect the instrument to a PC.
The instrument is not powered by the PC
when the two are connected.
Accessory Case CF-A25
Stows the target masks, zero calibration box, white
calibration plate and other accessories.
CF-A23
CF-A22
（NC: For noncontact
（XUSAV）
measurement）
φ34 mm
5 × 7 mm
0.75 ×
φ8 mm 0.75 × 1 mm
1 mm
8
Advertisement
Table of Contents
