Attaching/Detaching The Benchtop Base (Optional); Attaching The Benchtop Base; Detaching The Benchtop Base - Konica Minolta CF-300 Instruction Manual

Attaching/Detaching the Benchtop Base
WARNING
Be careful not to pinch hands in parts of the instrument or accessories
that open and close. Doing so may result in injury.
Do not set the instrument on wobbly stands, inclined surfaces or other unstable places. Injury may occur
if the instrument falls or topples over. Moreover, when carrying the instrument, be careful not to drop it.
Note
c The sample holder is positioned to ensure proper measurement before leaving
the factory. For that reason, never detach the sample holder.
c If the sample holder is detached by mistake, contact the nearest Konica Minolta-authorized
service facility. The sample holder requires repositioning by the manufacturer.
Memo Before attaching or detaching the benchtop base, unplug the AC adaptor and cables from the instrument.

Attaching the Benchtop Base

1
. Loosely install the included screws in the four
screw holes on the bottom of the instrument
indicated by arrows at right.
(Leave a gap of 2 to 3 mm between the screw
head and the bottom)
2
. Slide the four mounting holes (A) of the
benchtop base over the heads of the screws
and shift the base in the direction of the arrow.
3
. Fully tighten the the 4 screws.

Detaching the Benchtop Base

1
. Loosen the 4 screws that lock the benchtop
base to the instrument.
2
. Lift the bench top base upward in the direction
of the arrow in the figure, and then pull
the bench top base straight away from the
instrument to detach it. Remove the 4 screws
remaining in the instrument.
Memo Stow the removed screws inside the carrying
case etc. so that they do not become lost.
A
21
(Optional)