Table of Contents
Advertisement
QUICK START GUIDE
Step 5 – Connect DC Output
•
There are 16 DC terminal Outputs and 16 DC Output Returns - 8 per Power Express Converter Module.
•
Strip the output wire 1/2".
•
Push the screw driver into release hole (#0 Phillips or 1/8" flat screw driver) at a downward angle.
•
Insert wire fully into wire entry.
•
Pull wire to verify insertion.
-48V DC Output Terminals
Step 6 - Set Controller Jumpers
•
LAN port may be temporarily set to Local mode, but must be set to Network mode for remote monitoring.
•
Alarm relays may be set to "Open on Alarm" or "Close on Alarm"
Page 12
© 2021 ABB. All rights reserved.
DC Output Return Terminals
Figure 9: DC Output Connection
Local/Network
Jumper
USB Craft Port
Figure 10: Controller Jumpers
Alarm relay
jumpers
Release Hole
Wire Entry
24 - 8 gauge
Version 1.0
Advertisement
Table of Contents
