Troubleshooting - Mobius Mini2 User Manual

Trouble shooting
Q. When I press the Power button, nothing happens.
A. The battery is flat or defective. Replace or charge the battery. Use a paper clip or similar
object to press the Reset button.
Q. When I press the Power button, the Red LED turns on for about 2 seconds but then turns off.
A. Most likely the camera has been configured for Delayed Power-On. See above "Turn On
Camera". Modify this parameter if you require Fast-Power-On.
Q. When I turn on the camera the yellow and red LEDs blink rapidly about 20 times. The camera
then turns off.
A. There is no SD card inserted or the SD card is not making proper contact. Insert the card
and/or clean the contacts.
Q. When I try to record a video or photo the yellow and blue LEDs blink slowly about 4 times.
The blinking rate then increases and the camera turns off after a few seconds.
A. There is a problem with the SD card.
•
The card is full. Format the card using SDFormatter, if possible.
•
The card is not formatted correctly. Format the card using SDFormatter, if possible.
Q. The camera functions normally but only records very short clips and may turn off.
A. This can be caused by the following:
•
The battery may not be charged. Charge the battery for about 2 hours until the green LED
turns off.
•
The battery is too cold to provide the power needed to record video. Keep the battery
warm before using the camera in cold temperatures (around freezing and below).
•
Check the integrity of your card by using the program h2testw to make sure your card is
genuine and not a fake card that has been up-rated.
•
The card used is not compatible with the camera. Use class 10 cards for best results.
Q. The camera does not react.
A. The firmware may have entered a continuous loop, or the battery may be discharged.
•
Make sure the battery is fully charged.
•
Use a paper clip or similar object to press the Reset button. This should force the camera
to be turned off.
•
Wait a couple of seconds.
•
Turn on the camera if it does not turn on automatically.
•
As a last resort, disconnect the battery and reconnect again after waiting 30 seconds.