Mobius Mini2 User Manual page 2

In-Camera Formatting
The Camera contains a built-in formatter which should be used to format the SD card.
1. Disconnect the camera and ensure it is turned off.
2. Turn on the camera and wait until it is in one of the Standby modes (steady yellow or blue
LED).
3. ► If the camera was set to auto-record, press the Shutter button to stop the recording.
4. Press and hold down the Shutter button for about 2 seconds.
button.
5. Quickly press the Mode button 4 times.
6. After a second or two the yellow or blue LED will begin to blink rapidly.
7. ► If the LEDs don't start to blink, release the buttons and start over again.
8. Release both buttons as soon as the LED starts to blink.
9. You now have up to 15 seconds to confirm you wish to format the card.
10. Press the Shutter button to confirm that the card can be formatted, OR, press the Power
button to abort the formatting.
11. ► If no button is pressed within 15 seconds the camera will turn off.
12. The top LED will blink while the card is formatted.
13. The camera will turn off when formatting is finished.
USB connector
The Mobius Mini2 uses a standard 5 pin Mini USB connector which is used for USB data
transfer and charging. A/V out (TV-Out, Video-Out) is not supported.
Cables
Always use HIGH QUALITY USB cables. Cheap cables may lead to all sorts of problems. If
possible, keep the cable as short as possible.
Before you start
Before using the camera for the first time, ensure the internal battery is fully charged. See below
under "Charging".
The Reset button
The reset button is in the small hole located below and to the right of the USB Socket (looking at
the camera from the rear). It can be pressed by carefully inserting a bent paper clip or similar
instrument. The Reset button should only be pressed in case the camera no longer reacts to
button presses. Pressing the Reset button will force the processor to restart. No parameter
settings will be lost and the RTC (Real Time Clock) will not be interrupted.
The Power button
The power button is used to turn the camera on or off. See below "Turn On camera" and "Turn
Off camera".
DO NOT RELEASE the