Table of Contents
Advertisement
The Mode button
The Mode button enables the camera to be sequentially switched between 3 different modes.
Each button press advances to the next mode indicated by the LED color.
•
Video Mode 1 (yellow LED). The frame rate and resolution can be individually configured.
•
Video Mode 2 (blue LED). The frame rate and resolution can be individually configured.
•
Photo Mode (red LED) which also includes Time-Lapse photos.
The Shutter button
Press the shutter button to start or end a video recording or to take a picture.
LED status indicators
The following LED states are for a camera not connected to the PC.
○
Steady Yellow - The camera is in Video Mode 1 and is on standby.
☼
Slowly flashing Yellow (1 sec. On, 1 sec. Off) - The camera is in Video Mode 1 and is
recording video. The Video Recording indicator (see configuration) must be ON for this to work.
○
Steady Blue - The camera is in Video Mode and is on standby.
☼
Slowly flashing Blue (1 sec. On, 1 sec. Off) - The camera is in Video Mode 2 and is recording
video. The Video Recording indicator (see configuration) must be ON for this to work.
○
Steady Red - The camera is in Photo Mode.
☼/☼
One Red/Yellow flash - The camera has taken a picture.
○
Steady Green - The battery is charging.
The rear LED
If the camera is configured to show the Recording Indicator, then the rear LED will normally blink
in sequence with the main LED while recording or in standby mode.
Connecting the camera to the PC
Make sure a card is inserted and the camera is turned OFF if you want to access the camera as
an external device (disk drive, setup). Always connect the camera directly to the PC. Do not use
a USB hub.
► You cannot record video or photos if the camera is connected to the PC as an external drive.
Advertisement
Table of Contents
