Turn Off Camera; Switching Between Modes - Mobius Mini2 User Manual

Charging
•
Connect one end of the supplied standard USB cable to the camera.
•
Connect the other end to a USB, 5V DC power source (wall charger, PC or external
battery).
•
When the yellow or blue LED turns on, press the Power button for about two seconds to
turn the camera OFF.
When charging, the green LED will be on. It will turn off when the battery is fully charged.
Charging takes about 2 hours for a fully discharged battery with the camera turned off and
connected to an external USB Charger. Batteries are not covered under warranty. If charged
with under-rated chargers or by using a USB hub without an additional power supply, expect
longer charging times. For optimum results, the charging voltage should be +5V under load.
Only use quality chargers capable of supplying at least 1000mA (1A) and a stable voltage of 5V.
Low quality chargers may not be able to supply enough current and can lead to premature
battery failure or, in the worst case, even destroy the camera.
A new and fully charged battery will record about 60 minutes of 1080p 60fps videos.
Automatic Power Off from Standby mode
If the camera is in standby mode you must take a picture(s) or start a video recording within *30
seconds. The camera will automatically turn off after *30 seconds of no activity.
*This value can be set using the setup program. Automatic Power Off can also disabled.
Turn on Camera
The camera can be configured to turn on immediately the power button is pressed or it can be
configured to only turn on after pressing the power button for a few seconds.
The camera can be configured to power up in either Mode1 or Mode2 and is ready for use once
the Yellow or Blue LED turns on, indicating the camera is in standby mode.
► Delayed Power-On is useful in order to prevent the camera from being inadvertently turned
on.
► Do not keep the power button pressed for too long. Doing so will first turn on the camera and
then turn it off again.

Turn off Camera

To turn off the camera, first stop any recordings that may be running by pressing the shutter
button and then press the power button for about 2 seconds until the camera turns off.

Switching between modes

The camera can be switched between the different modes by pressing the Mode button. Each
button click advances the camera to the next mode. Video Mode1 - Video Mode2 - Photo Mode -
Video Mode1 etc.