Getting Started; Overview - ST STEVAL-IFP044V1 User Manual

1

Getting started

1.1

Overview

The STEVAL-IFP044V1
overtemperature protection for safe output load control.
The board is designed to meet application requirements in terms of galvanic isolation between user and power
interfaces. This requirement is satisfied by optical isolation implemented through four optocouplers (ISO1, ISO2,
ISO3 and ISO4) for signal forward to the device and FLT pins for feedback diagnostic signals.
The STEVAL-IFP044V1
• Based on
– Operating range up to 60 V/5.7 A
– Low power dissipation (R
– Fast decay for inductive loads
– Smart driving of capacitive load
– Under-voltage lock-out
– Per-channel overload and over-temperature protections
– QFN48L 8x6 mm package
• Application board operating range: 8 to 33 V/0 to 5.7 A
• Extended voltage operating range (J3 open) up to 60 V
• Green LEDs for output on/off status
• Red LEDs for per-channel diagnostic (overload and overheating)
• 5 kV galvanic isolation
• Supply rail reverse polarity protection
• Compatible with
• Equipped with Arduino UNO R3 connectors
• CE certified
• RoHS and China RoHS compliant
• Not FCC approved for resale
UM3050 - Rev 1
embeds the IPS2050HQ-32
features:
IPS2050HQ-32 dual high-side switch, which features:
ON(MAX)
STM32 Nucleo development boards
intelligent power switch (IPS), featuring overcurrent and
= 50 mΩ)
UM3050
Getting started
page 2/17