Table of Contents
Advertisement
Troubleshooting
Fault
Light on, but motor
does not work
Light does not work,
motor does not work
Oil leakage
Lights not working
Insufficient suction
The Rangehood
inclines
NOTE: Any electrical repairs to this appliance must conform to New Zealand standards and
laws. Please contact the service center if in any doubt before undertaking any of the above.
Always disconnect the unit from the power source when opening the unit.
Possible Cause
Fan has switch turned off
Fan switch has failed
Motor has failed
The house's fuse has blown
The mains power cable is loose
or disconnected
The one way valve and the outlet
are not tightly sealed
Leakage from the connection of
chimney and cover
Broken or faulty bulbs
The distance between the
rangehood and the gas top is too
far
The fixing screw is not tight
enough
25
Solution
Select a fan switch position.
Contact service center.
Contact service center
rangehood's ability to extract
efficiently will be reduced.
.
Reset/Replace fuses.
Refit mains power cable to power
outlet. Then switch power outlet on.
Remove the one way valve and re-
seal with sealant.
Take chimney down and seal.
Replace bulbs as per
instruction.
Refit the rangehood to the correct
distance.
Tighten the hanging screw and
make it horizontal.
, or the
Advertisement
Table of Contents
