Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Smeg PUM601X
Summary of Contents for Smeg PUM601X
- Page 1 User Instruction Manual PUM601X PUM901X...
- Page 2 CONTENTS 1) WARNING 2) INSTALLATION INSTRUCTIONS 3) OPERATION 4) LIGHT REPLACEMENT 5) CHARCOAL FILTER INSTALLATION 6) MAINTENANCE 7) ATTENTION 8) TROUBLESHOOTING...
- Page 3 1. WARNING Young children should be supervised to ensure that they do not play with the appliance. The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervised or instruction concerning use of the appliance by a responsible person for their safely.
-
Page 4: Installation
1. Use four ST4*8mm screws to fix the mounting bracket onto the hood. Then put two ST4*30mm screws into the wall. Hang the hood onto the wall. 2. Use ST4*14mm screws to tighten the hood to the cabinet. PUM601X needs ten screws. PUM901X needs twelve screws. - Page 5 Method 2 1. Use four ST4*8mm screws to fix the mounting bracket onto the hood. Then put two ST4*30mm screws into the wall. Hang the hood onto the wall. 2. Use eight ST4*14mm screws to fix the hood onto the cabinet from the sides.
-
Page 6: Operation
3. OPERATION: 1）Push the low button, indicated by a fan with 3 blades, and the motor will run at a low speed. An indicator light will also illuminate. Push it again and the motor will stop. 2）Push the medium button, indicated by a fan with 4 blades and the motor will run at a medium speed. -
Page 7: Maintenance
6. MAINTENANCE 1． The rangehood and its filter mesh should be cleaned regularly in order to keep in good working order. Because the grease filters are made of metal, do not clean the filters with detergents that will corrode metal products. Clean the filters as below: Method one: Put the filter in water (40℃-50℃), pour in some grease-loosening... - Page 8 PUM601X Dimensional Drawing PUM901X Dimensional Drawing...
-
Page 9: Troubleshooting
8. TROUBLESHOOTING Fault Cause Solution The leaf blocked Get rid of the blocking The capacitor damaged Replace capacitor Light on, but motor motor jammed bearing Replace motor does not work damaged The internal with of motor off or a Replace motor bad smell from the motor Beside the above mentioned, check the following: Light does not work,...