Smeg SH670LSS1 User Manual page 15

Fitting the chimney
Take the two chimney sections (C) and (D).
4.
 Rest the bottom of chimney section (C) on the top of the
rangehood. You should take care to position the tabs on
the chimney section into the rear of the rangehood.
 Mark the side measurement of both sides of chimney
section (C) on the wall with a pencil.
Lift chimney section (D) upwards until it reaches the ceiling. You must ensure that it is
5.
perpendicular to the rangehood.

Mark the side measurements of both sides of chimney section (D) on the wall with a
pencil and then remove chimney section (D).
Take the flat bracket (E) and place it between the two pencil marks that you made in Step
6.
4.
 Keeping the bracket in contact with the wall, use a pencil to mark on the wall the
anchoring holes that are cut out of the bracket.
Using a 6 mm drill bit, drill out two holes on the pencil markings that you made in step 6.
7.
Insert rawl/wall plugs into the holes and then uses a screwdriver to secure the flat bracket
to the wall.
 Refit chimney section (C) to the hood and fix it onto the rangehood using the two
screws that are supplied.
 Secure the top of chimney section (C) to the flat bracket, using the screws provided.
15