Installing Your Rangehood - Smeg SH670LSS1 User Manual

Installing Your Rangehood

IMPORTANT: YOU WILL HAVE TO DECIDE BEFORE INSTALLING YOUR RANGEHOOD
WHETHER TO USE IT IN EXTRACTION MODE OR RECIRCULATION MODE. PLEASE REFER
TO PAGE 12 TO UNDERSTAND THE DIFFERENCES BETWEEN THESE TWO MODES.
We recommend that at least two people install this rangehood.

If you are using the appliance in recirculation mode, then please note that all of the vent

in the upper chimney section must be exposed. You will have to take this into account
when calculating the minimum height of the extractor when installed.
If the recirculation vents are obstructed then the efficiency of the extraction will be

affected and could damage the motor.
IMPORTANT: YOUR RANGEHOOD SHOULD BE CONNECTED TO YOUR MAINS SUPPLY
AFTER THE REST OF THE INSTALLATION PROCESS HAS BEEN COMPLETED. AT THE TIME
OF INSTALLTION TURN THE RANGEHOOD OFF AND UNPLUG IT FROM THE OUTLET.
Installation of the Vent Outside
How to install the V-Flap
If the rangehood does not have an assembled V-flap (1) your installer should install the half-
parts to its body. The images below only show an example of how to install the V-flap,
because the outlet may vary according to different models and configurations.
To mount the V-flap (1) your installer should:
1. Mount two half-parts (2) into the body (6);
2. The pin (3) should be top oriented;
13