Table of Contents
Advertisement
Jøtul F 35 130074_1 6/22
6.4 Gasket Replacement
Tools needed:
• needle nose pliers
• 4mm hex key
• wire brush
• gasket cement
1. Use the pliers to remove the small C-clips from the door hinge
pins. Remove the door from the stove and place it face down
on a protected surface.
2. Use the hex key to remove the warning label plate from the
back of the door.
3. Use pliers to remove the old gasket and adhesive from the
door.
4. Thoroughly clean the channel with a wire brush.
5. Apply a small bead of gasket cement to the channel as shown
in fig. 19. DO NOT APPLY CEMENT TO THE GLASS CLIPS
OR THE CLIP LANDING AREAS.
6. Starting at the center of the gasket length and the top center
of the channel, gently press each gasket half into the channel.
Do not stretch the gasket. Wrap the ends at the center of the
bottom as shown in fig. 19.
7. Replace the Warning Plate.
8. Replace the door. Close and latch the door and then reopen.
Wipe away any excess cement that may have squeezed out
from around the gasket.
9. Replace the C-clips onto the hinge pins.
Description
1.
Door Gasket
2. Glass Gasket
3. Screw, M6x10 Button Hd.
4. Glass Clip Ass'y.
5. Glass Panel
6. Warning Plate
Gasket Cement Area
Glass Clip Landing-
APPLY NO CEMENT
6
Figure 19. Glass and Gasket Replacement
23
Part Number
223858
200024
117978
157642
224923
226905
2
3
6.5 Glass Replacement
Tools needed:
• 4mm hex key
1. Lift the door gasket over the glass clips enough to expose the
clip button head screws. See fig. 20. Use the 4mm hex key to
loosen the glass clips just enough to remove the glass panel. It is
not necessary to completely remove the clips from the door.
If replacing the glass gasket, follow steps 3-5 in section 6.4.
2. Position the new glass panel and tighten the glass clips just
snug. Avoid overtightening or placing uneven pressure on the
glass.
3. Reposition the door gasket over the glass clips.
Figure 20. Loosen the glass clips.
4
5
4
3
3
1
Advertisement
Table of Contents
