Table of Contents
Advertisement
139946-18 F 500 V3 Oslo May 2022
6.4 Enamel Care
• DO NOT ATTEMPT TO CLEAN HOT ENAMEL
SURFACES. Clean only cold enamel surfaces with a
soft damp cloth and polish with a clean dry cloth. Most
stains can be removed with a solution of baking soda and
vinegar. Let this solution sit on the stain for a minute
or two before rubbing it dry with a damp cloth. Organic
cleaning commercial cleaning solutions, such as Citra-
Solv®, can also be effective.
• DO NOT USE SOAPY OR ABRASIVE SOLUTIONS.
These can cause stains. Coffee, tea, and fruit jucies will
also cause stains.
• AVOID CONTACT WITH METAL OBJECTS. Trivets,
kettles, or pots, can damage the enamel
6.5 Glass Care
Cleaning
While the air wash and high temperatures of normal
operation will combine to keep the glass free of heavy
deposits, it will occasionally be necessary to clean
carbon and fly ash off the glass. If allowed to remain
for an extended period of time, these deposits can
eventually cause the glass surface to become etched
and cloudy.
• USE ONLY AMMONIA-FREE, NON-ABRASSIVE
STOVE GLASS CLEANER
• DO NOT ATTEMPT TO CLEAN HOT GLASS.
• CLEAN GLASS ONLY AT ROOM TEMPERATURE.
Glass Replacement
1. Remove the doors from the stove and place on a flat
surface.
2. Carefully remove all of the glass clips from the inside
of the door.
3. Gently remove all pieces of the glass panel and gasket.
4. Remove all remaining gasket remnants with a wire
brush.
5. Apply a small bead of gasket/stove cement and the
new gasket. Do not overlap the ends of the gasket
rope.
6. Important: Gradually tighten the glass clips in an
alternating pattern as you would tighten the lugs on an
automobile wheel.
14
.
/ See Fig. 15
6.6 Gaskets
Check door and glass panel gaskets for tightness. To check
the seal of the front door, close and latch the door on a dollar
bill and slowly try to pull the dollar bill free. If it can be easily
removed, the seal is too loose. Check several spots around the
door, and repeat the procedure on the ash pan door as well.
Gasket Replacement
Universal Wood Stove Gasket Kit #157050 is available
from your dealer to replace all the gaskets in the F 500 V3.
Self-adhesive gaskets do not require cement for installation.
1. Use pliers and a putty knife to remove the old gasket from the
door.
2. Thoroughly clean the channel with a wire brush.
3. Apply a small bead of cement to the channel.
4. Gently press the new gasket into the cement to seat it in the
channel. Close and latch the door and then reopen. Wipe
any excess cement squeezed out from around the gasket.
F 500 V3 Gaskets
Description
Size
Top Cover
3/8 in.
Top Plate
3/8 in.
Smoke Outlet
1/4 in.
Ash Housing
1/4 in.
Ash Pan Door
3/8 in.
Front Door
3/8 in.
Left Side Door
3/8 in.
Glass
3/8 in.
Length
3.5 ft.
7 ft.
3 ft.
4 ft.
4 ft.
6 ft.
4.5 ft.
5 ft.
Advertisement
Table of Contents
