2.2
Installing the PoE+ Managed Injector Hub
This section describes how to install your PoE+ Managed Injector Hub and make connections to the PoE+
Managed Injector Hub. Please read the following topics and perform the procedures in the order being
presented. PLANET PoE+ Managed Injector Hub does not need software configuration.
2.2.1 Desktop Installation
To install a PoE+ Managed Injector Hub on a desktop or shelf, simply complete the following steps:
Step 1: Attach the rubber feet to the recessed areas on the bottom of the PoE+ Managed Injector Hub.
Step 2: Place the PoE+ Managed Injector Hub on a desktop or shelf near an AC power source.
Step 3: Keep enough ventilation space between the PoE+ Managed Injector Hub and the surrounding
objects.
When choosing a location, please keep in mind the environmental restrictions discussed
in Chapter 1, Section 5, under Specifications.
Step 4: Connect your PoE+ Managed Injector Hub to network 802.3at/802.3af powered devices (PD) and
Switch.
A. Connect one end of a standard network cable to the upper stack 10/100/1000T RJ45 ports on the
front of the PoE+ Managed Injector Hub.
B. Connect the other end of the cable to the 802.3at / 802.3af powered devices (PD) such as IP phone,
wireless access point, IP camera, splitter, or switch etc.
C. Connect one end of a standard network cable to the relative lower stack 10/100/1000T RJ45 port on
the front of the PoE+ Managed Injector Hub.
D. Connect the other end of the cable to the port of Switch.
Connecting to the PoE+ Managed Injector Hub requires UTP Category 5e/6 network
cabling with RJ45 tips. For more information, please see the Cabling Specification in
Appendix A.
Step 5: Supply Power to the PoE+ Managed Injector Hub.
A. Connect one end of the power cable to the PoE+ Managed Injector Hub.
B. Connect the power plug of the power cable to a standard wall outlet.
When the PoE+ Managed Injector Hub receives power, the Power LED should remain solid Green.