Getting Ready to Install the EH-501/EH-801
Before installing the EH-501/EH-801 Hub, you should determine
the installation location.
♦ Make sure that the cable distance between the concentrator
and the host device is not longer than 328 feet (10Base-T), or
606 feet(10Base-2) including all connection cables.
♦ Check if you are using a external AC power adapter, 7.5 V DC
output, 400~700mA required.
Warning:
Please make sure you are using a power adapter of the right
type; otherwise, the warranty will be invalidated.
♦ Make sure there is enough room to service the Hub and to
make cable connections to the rear panel.
♦ Avoid direct sunlight, heat vents and warm air exhaust from
other equipment.
Installing the Hub
You can place the Hub on a desk or mount it on the wall.
The wall-mounting design provides space-saving and flexibility
in cable routing and expansion. Fix the two screws on the wall,
CHAPTER 3 INSTALLATION