Figure 6-12 Connecting The E1 Cable - Raisecom RC1201-2GE16E1T1 Manual

Raisecom
RC1201-2GE16E1T1 Product Description
Connecting E1 cables
The interface type of the E1 cable used by the RC1201-2GE16E1T1 is Rj45.
The E1 cable is used to connect the RC1201-2GE16E1T1 to other TDM devices.
Connect the E1 cable as below:
Step 1 Make E1 cables that are of proper length according to cabling path.
Step 2 Connect the RJ45 connector of the E1 cable to the E1 interface on the RC1201-2GE16E1T1,
as shown in Figure 6-12.

Figure 6-12 Connecting the E1 cable

Step 3 Connect the other connector of the E1 cable to the peer device.
Connecting optical fiber
Do not look directly at the fiber optic connector connected with laser, or it may injure
your eyes.







Do not stretch optical fiber with power and bend fiber excessively. The curvature
radius is equal to or greater than 40 mm.
In chassis, the tail fiber determines its routing direction according to the location of
components.
Retain a certain margin of fiber in rack when connecting, and put away the extra
tail fiber.
TX and RX interfaces should be connected correctly.
Ensure that the optical connector joint is clean and cover dust cap timely after use.
Bind single-core tail fiber with magic tape.
Do not bind the fiber too tight so as not to affect the signal transmission quality.
Raisecom Technology Co., Ltd.
6 Installation
75