Accessing The Camera From A Web; Enabling The Network Connection On The Camera; Setting-Up The Computer; Os/Web Browser - Sony SRG-X40UH Operating Instructions Manual

Accessing the Camera from a Web

Browser
You can access the camera from a web browser
on a computer to upgrade the firmware.
An IP address must be set on the camera for
access from a web browser. For details on IP
address settings, refer to "RM-IP Setup Tool
Guide."
Enabling the Network
Connection on the Camera
The network connection on the camera must be
enabled to access the camera from a web
browser. To enable/disable the network
connection, use the OSD menu (SYSTEM –
NETWORK).
Note
After the SYSTEM - NETWORK setting is changed
in the OSD menu, restart the camera.

Setting-up the Computer

System configurations required for the Computer
are shown in the following (as of July 2022).

OS/Web browser

Windows
OS version
Windows 11 (64-bit version)
Windows 10 (64-bit version)
Web browser
Google Chrome (Recommended)
Microsoft Edge
macOS
OS version
macOS 10.15
Web browser
Google Chrome (Recommended)
Accessing the Camera from a
Web Browser
Start a web browser on the computer and enter
the IP address of the camera in the address bar.
Authentication by user ID and password is
required to access the camera.
Changing the Initial
Password
Accessing the camera from a web browser for
the first time requires to change the
administrator password. The default
administrator name and password are as follows.
Administrator name: admin
Password: Admin_1234
The password should be between 8 and 32
alphanumeric characters. The password must
contain alphanumeric characters.
Note
When changing the password, use the network
configuration that an unintended third party
cannot access.
43