Status Menu; Down Converter Menu - Sony HD 3CCD COLOR BRC-H700 Operating Instructions Manual

STATUS Menu

The STATUS menu is used to display the settings
selected with the menus.
< S T A T U S >
E X P O S U R E
A E S P E E D
A G C L I M I T
I R I S L I M I T
E X - C O M P
B A C K L I G H T
S P O T L I G H T
F O C U S
The STATUS menu consists of PAGE1 to PAGE5. This
menu only displays the current menu settings, and you
cannot change them with the menu.
PAGE1: Shows the settings selected with the
EXPOSURE and FOCUS menus.
PAGE2: Shows the settings selected with the COLOR
menu.
PAGE3: Shows the settings selected with the PAN TILT
ZOOM menu.
PAGE4: Shows the STEADY SHOT, IR-RECEIVE,
IMG-FLIP, REVERSE PAN, DISPLAY INFO,
COLOR BAR and FLICKER CANCEL settings
selected with the SYSTEM menu.
PAGE5: Shows the output settings of the output
connector on the camera, the firmware versions of
the BRC-H700 and BRU-H700 (if connected), etc.
36
STATUS Menu / DOWN CONVERTER Menu
P A G E 1
F U L L A U T O
M I D
1 8 dB
O F F
O F F 0
O F F
O F F
A U T O
DOWN CONVERTER
Menu
The DOWN CONVERTER menu is displayed only
when the HFBK-SD1 SD Interface Board is inserted
into the card slot of the camera.
< D O W N C O N V E R T E R >
> D - S U B O U T 1
D - S U B O U T 2
I M G S I Z E
S E T U P
D-SUB OUT1
Select the component signal output from the MONITOR
connector (D-sub 9-pin) on the HFBK-SD1 SD
Interface Board.
YPbPr: Outputs analog component signals.
RGB: Outputs RGB signals.
ADD SYNC
Appears when RGB is selected with D-SUB OUT1 and
specifies whether to add a sync signal.
RGB: Outputs each R, G and B signal with a sync signal
added.
G: Outputs the G signal with a sync signal added.
OFF: Outputs each signal with no sync signal added.
D-SUB OUT2
Select the output signal from the MONITOR connector
on the HFBK-SD1 SD Interface Board.
VBS: Outputs analog composite signals.
Y/C: Outputs S-video signals.
IMG-SIZE (image size)
Select the aspect ratio of the output signal.
16:9[LETTER]: The image is displayed in 16:9
letterbox.
4:3[CROP]: The image is displayed in 4:3 edge crop.
4:3[SQUEEZE]: The image is displayed in 4:3
squeeze.
SETUP
Select whether 7.5IRE setup is added to output signals.
ON: Outputs signals with 7.5IRE setup added.
OFF: Outputs signals with no 7.5IRE setup added.
Y P P
b r
V B S
1 6 : 9 [ L E T T E R ]
O F F