Advertisement
Front Bumper Center License Plate Bracket
2021+ Bronco
LPBR-01
TOOLS
REQUIRED
-T40 Torx Bit
-M10 Wrench
-M4 Allen Bit
WARNINGS/CAUTIONS BEFORE STARTING INSTALLATION
Before you install this kit —
instructions, warnings, cautions, and notes contained in
this installation instruction guide. Consult your vehicle
owner's manual for proper disconnection of electrical and
lifting of vehicle if required for installation of this product.
This install may require some technical skills and
knowledge of basic mechanical work. If you do not feel that
you are capable of performing this install please take this
product to a trained professional.
After reading this guide please contact us with any
questions or concerns before installing product.
Customer Service: 855-680-9595
DV8 Offroad is not responsible for any bodily injury or harm to you
or your vehicle as a result of an improper install.
6400 SYCAMORE CANYON BLVD.
RIVERSIDE, CALIFORNIA 92507
855-680-9595
WWW.DV8OFFROAD.COM
SKILL
LEVEL
- Novice/Intermediate
- 1 Person
Little skill level required, you can
easily install it by yourself however,
additional help will be useful.
Read and understand all
PRODUCT
INSTALLATION
TIME
- .5 Hours
Time to install this should take
approximately .5 Hour.
Proper installation of this kit required knowledge of the factory
recommended procedures for removal and installation of original
equipment components. We recommend that the factory shop manual
and any special tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper knowledge of the
factory recommended procedures may affect the performance of these
components and the safety of the vehicle
• Always wear eye protection when operating power tools
Inspect all contents of this package to make sure product is not damaged
and all installation hardware has been included. If parts are missing from
kit, please be prepared to provide the following information
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
MANUAL
REQUIRED
855-680-9595
NEED HELP?
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for DV8 LPBR-01
Summary of Contents for DV8 LPBR-01
- Page 1 1. Name of purchase location Customer Service: 855-680-9595 2. Bar Code on side of box DV8 Offroad is not responsible for any bodily injury or harm to you 3. Date above bar code or your vehicle as a result of an improper install.
- Page 2 INSTALLATION MANUAL STEP Begin by unpacking all items and inspecting for missing pieces or damage. If you have any concerns, please contact the company the product was purchased from. Hardware Included: (4) M6x15mm Bolts (4) M6 Lock Nuts (8) M6 Flat Washer STEP Begin by removing three factory screws from the bumper using a T40.
- Page 3 INSTALLATION MANUAL STEP Install bracket with the T40 on the two outside bolt holes. NOTE: Slide bracket upwards to ensure clearance for license plate hardware. You will not reinstall the center bolt if using this license plate bracket. STEP Secure license plate using four provided M6 hardware on both sides of the bracket.
- Page 4 INSTALLATION MANUAL STEP Double check all hardware is secure and if running optional pods, wire lights as desired. 855-680-9595 NEED HELP?
Need help?
Do you have a question about the LPBR-01 and is the answer not in the manual?
Questions and answers