Related Manuals for BeefEater BSHI56SA
Summary of Contents for BeefEater BSHI56SA
- Page 1 INTEGRATED Assembly and Operating Instructions SERIES BSHI56SA, BSLI56SA AUSTRALIA / NEW ZEALAND FOR OUTDOOR USE ONLY...
-
Page 2: Table Of Contents
CONGRATULATIONS CONTENTS Dear customer, General warnings ��������������������������������������������������������������������������3 Integrated barbecue product description �������������������������������������4 Congratulations and thank you for choosing our barbecue� Parts �����������������������������������������������������������������������������������������������5 We are sure you will find it a pleasure to use� Before you use the barbecue, we recommend that you read through the Gas specifications ��������������������������������������������������������������������������6 relevant sections of this manual, which provide a description Leak test procedure ����������������������������������������������������������������������7... -
Page 3: General Warnings
IMPORTANT SAFETY INSTRUCTIONS Please read the user manual carefully and store in a handy place for later reference� WARNING WARNING • Do not lean over barbecue when lighting. TIPS & INFORMATION • Do not leave the barbecue unattended when alight. IMPORTANT •... -
Page 4: Integrated Barbecue Product Description
Cast Iron Hotplate Removable oil reservoir located at front of cooking surface (not illustrated) Flame tamers x 2 located under grills (not illustrated) Integrated barbecue with roasting hood BSHI56SA Roasting hood Warming racks Battery cover Gas connection point Burner controls... -
Page 5: Parts
PARTS DESCRIPTION DESCRIPTION Rear heat Natural gas shield regulator and installation pipe Flame LPG hose tamers and regulator assembly Oil reservoirs 1 Plastic bag, containing this instruction book, labels, 1 fibre washer, match holder and chain EITHER Roasting hood Cast Iron and base plate assembly... -
Page 6: Gas Specifications
GAS SPECIFICATIONS Natural gas installation NATURAL UNIVERSAL GAS TYPE PROPANE This barbecue is set up for Natural Gas and is labelled Maximum gas 67�2 MJ/h 64�0 MJ/h 71�0 MJ/h accordingly� A Universal LPG and Propane conversion kit is consumption included if required� Injector office 1�75mm 0�90mm... -
Page 7: Leak Test Procedure
LEAK TEST PROCEDURE Leak test procedure • Ensure all gas valves are in the ‘OFF’ position� • In a small container, mix a solution of water and detergent or soap� • After connection of the hose, turn on the gas supply at the gas bottle or mains as appropriate�... -
Page 8: Universal Lpg And Propane Installation
UNIVERSAL LPG AND PROPANE INSTALLATION Remove burner to access injector NOTE: Conversion of this unit to LPG or Propane must be carried out by a qualified licensed person and a Certificate of Compliance must be issued to the owner on completion of the installation and conversion�... - Page 9 UNIVERSAL LPG AND PROPANE INSTALLATION This barbecue is set up for Natural Gas and is labelled Gas bottle safety information accordingly� A Universal LPG or Propane Gas conversion Kit • This appliance is designed to use a 9kg (20 lbs) is supplied if required�...
-
Page 10: Installation Warnings
UNIVERSAL LPG AND INSTALLATION WARNINGS PROPANE INSTALLATION WARNING WARNING • This appliance shall only be used in an above ground, open air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind or natural Barbecue gas inlet convection�... -
Page 11: Installation Instructions
INSTALLATION INSTRUCTIONS Installation warnings Choosing a location The mounting enclosure When planning the location and preparing the installation • The barbecue requires a non-combustible barrier under structure for this appliance note the following: the barbecue to prevent excessive temperatures being accessed�... - Page 12 DIMENSIONS Benchtop must be non- This side wall can be combustible material combustible material 100 min 100 min Non-combustible barrier – at least 30mm between barrier and This side wall can be base of the appliance combustible material 71mm minimum from cutout This front wall can Benchtop...
-
Page 13: Dimensions
DIMENSIONS WARNING! This appliance requires venting. An open area as indicated must be allowed for. A suitable grille can be fitted if desired. This vent area is to allow air into the enclosure for the correct combustion of gases and for the correct exhausting of the products of combustion. -
Page 14: Gas Requirements
GAS REQUIREMENTS ASSEMBLING THE BARBECUE Natural Gas requirements 1� Remove all components from box� 2� Attach heat shield to rear of unit by inserting the • The enclosure must be constructed so that access can three top tabs into the rear holes and sliding the be gained to the Natural Gas regulator at all times�... -
Page 15: Hotplate Configuration
HOTPLATE CONFIGURATION Install hotplates and grills as shown, ensuring that the flame tamers are located under the grills. NOTE: ensure that grill assemblies are orientated correctly so that the surface of the grill is sloping forward to allow oil to drain into oil reservoirs�... -
Page 16: Operating Instructions
OPERATING INSTRUCTIONS Control functions Preheating Before lighting the barbecue: For best cooking results it is recommended to preheat the barbecue prior to cooking� • Check that all hoses and gas fittings are tight� • This barbecue is fitted with high power burners� In •... -
Page 17: Lid Safety Lid - Slimline Lid Only
LID SAFETY – SLIMLINE ONLY CLEANING AND CARE The Electrolux Integrated barbecue has been constructed To ensure that the user remembers to turn off the gas before from select grade stainless steel which, if not cared for, may closing the lid, a pivoting safety leg has been fitted� discolour over time�... - Page 18 CLEANING AND CARE Other stainless steel surfaces Ensure all oil and food particles are removed� After cleaning complete, re-assemble ensuring the burner is correctly located over the injector� CAUTION! Cleaning the oil reservoirs Do not use abrasive or caustic cleaners, scourers or metal The Integrated barbecue has a unique oil management scrapers on these stainless steel surfaces as they may system which uses channels to drain all oil to the front...
-
Page 19: Maintenance
MAINTENANCE The ignition system To change the battery rotate the cover anti-clockwise to release� Lift off the cover to access spring and battery� Lift out the spring and battery� Replace with a new AA battery and replace the cover� Test by depressing the knob and an audible ‘clicking’... -
Page 20: Troubleshooting
TROUBLESHOOTING ACCESSORIES To order any of the following accessories and spare parts, or PROBLEM POSSIBLE REMEDY for more information on any other suitable accessories for this CAUSE product, please contact the Electrolux Customer Service Centre� Barbecue No gas Check isolation valve is ON� ACCESSORIES won’t light standard inclusions+... -
Page 21: Notes
NOTES NOTES... - Page 22 NOTES NOTES NOTES...
-
Page 23: Warranty
Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: BEEFEATER SIGNATURE BARBECUE 7. You may not make a claim under this warranty unless the defect claimed is This document sets out the terms and conditions of the product due to faulty or defective parts or workmanship. Electrolux is not liable in the warranties for Electrolux Appliances. - Page 24 For more information on all Beefeater products, or for dimension and installation information, call into your retailer, phone or email our customer care team or visit our website: AUSTRALIA phone: 1300 307 939 fax: 1800 356 669 email: customercare@electrolux.com.au web: beefeaterbbq.com...