CONGRATULATIONS CONTENTS Dear customer, General warnings ��������������������������������������������������������������������������3 Product description �����������������������������������������������������������������������4 Congratulations and thank you for choosing our barbecue� Gas specifications ��������������������������������������������������������������������������6 We are sure you will find it a pleasure to use� Before you use the barbecue, we recommend that you read through the LP/Propane gas installation ���������������������������������������������������������7 relevant sections of this manual, which provide a description Leak test procedure ����������������������������������������������������������������������7...
Do not test for leaks with a naked flame. manufacturer’s warranty. • Do not modify this appliance. Please contact your local Beefeater Distributor for additional information or assistance for an approved • Do not obstruct any ventilation of the barbecue.
For details of the kit and fitting soap� instructions appropriate for your market, please contact your local BeefEater distributor� • After connection of the hose, turn on the gas supply at the gas bottle or mains as appropriate�...
Gas conversion kits and fitting procedures vary in some markets� For details of the kit and fitting instructions appropriate for your market, please contact your local BeefEater distributor� Procedure 1� Remove screw and cover panel on base of burner box�...
GAS CONVERSION INSTRUCTIONS LPG SAFETY INFORMATION LPG safety information 5� Adjust primary air shutter (if necessary) by loosening the adjustment screw and rotating shutter to achieve the • Use only gas cylinders, which meet national and desired gap� Refer to “Primary Airation Gap” as defined regional codes�...
INSTALLATION WARNINGS WARNING WARNING • This appliance shall only be used in an above ground, open air situation with natural ventilation without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind or natural convection� This appliance is designed to be used outdoors and well ventilated indoor areas�...
INSTALLATION INSTRUCTIONS Installation warnings The mounting enclosure When planning the location and preparing the installation structure for this appliance note the following: • The barbecue requires a non-combustible barrier under • This appliance must be installed in accordance with your the barbecue to prevent excessive temperatures being local authority�...
INSTALLATION INSTRUCTIONS DIMENSIONS Side view - lid up 71mm min� From cutout Side view - lid down Bench width 600mm min� Vent 250mm x 25mm (required 540mm when installed separately to barbecue) WARNING! • This appliance requires venting� This vent is to allow air into the enclosure for the correct combustion of gases and for the correct exhausting of the products of combustion�...
GAS REQUIREMENTS POSITIONING OF BURNER Installation warnings LPG requirements • If an LPG bottle is to be stored in the enclosure under the burner unit, it must be isolated from the burner unit with a non-combustible panel� • Ventilation requirements for cylinder storage are: –...
BURNER OPERATION Control functions Operating the side Side Burner Before lighting the burner: Do not use oversized cookware or place cookware off-centre over the burner as this can cause high temperatures in • Check that all hoses and gas fittings are tight� control knob and surrounding panels�Cookware should be a minimum of 120mm diameter and should not exceed 300mm •...
PIVOTING SAFETY LEG To ensure that the user remembers to turn off the gas before closing the lid, a pivoting safety leg has been fitted� Pivoting Safety Leg When closing the lid the safety leg will pivot forward and rest against the trim surface to prevent the lid closing�...
CLEANING AND CARE Burner The Beefeater integrated burner has been constructed from select grade stainless steel which, if not cared for, may The burner ports should be checked for blockages and discolour over time� To keep your appliance looking its best cleared as required�...
Page 17
This appliance should be checked and serviced by an authorised service person every 2 years to ensure the appliance remains in a safe operating condition� (These services are not covered by warranty)� Replacement parts are available from your authorised BeefEater dealer� SERVICE AND MAINYENANCE SCEDULES EACH 6 MOM Check gas supply hose(s) for cracks and leaks ü...
TROUBLESHOOTING ACCESSORIES Installation warnings To order any of the following accessories and spare parts, or PROBLEM POSSIBLE REMEDY for more information on any other suitable accessories for this CAUSE product, please contact the Electrolux Customer Service Centre� Barbecue No gas Check isolation valve ACCESSORIES won’t light...
Conditions of Warranty Should any part fail due to defective workmanship or faulty 1. The appliance is delivered to the BeefEater distributor’s service department materials within the specified period from the date of purchase, or authorised service agent and freight charges both ways are paid by the BeefEater or its distributor will repair or, (at distributors option), owner.
Page 20
For more information on all Beefeater products, or for dimension and installation information, call into your retailer, phone or email our customer care team or visit our website: EUROPE BeefEater Europe PO Box 1238 Cheddar BS27 9AH United Kingdom phoneUK:...