PB TEEN Stuff Your Stuff Desk Assembly Instructions Manual

Stuff Your Stuff Desk
PRE-ASSEMBLY:
•
Please read all instructions before beginning assembly.
•
Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or
hardware.
PARTS INCLUDED:
A - Desk Top – 1 pc
C - Breadboard – 1 pc
HARDWARE INCLUDED:
E - Flat Washer – 8 pcs
H - Allen Wrench – 1 pc
ASSEMBLY INSTRUCTIONS:
1 . Lay the Desk Top (A) upside down on a soft surface or scratch-free surface.
2. Attach the Legs (B) by inserting the exposed threads into the pre-drilled holes on the corner blocks.
Secure with Flat Washers (E), Lock Washers (F) and Nuts (G) using Allen Wrench (H). See Figure 1.
3. Insert the Breadboard (C) into the Desk Top (A) with the insert nut on the breadboard facing up, as shown
in Figure 1. Insert and tighten Stoppers (I) into the insert nut on the Breadboard.
4. Turn the desk right-side up. Attach the Drawer (D) to the Desk Top (A) by inserting the Drawer's (D) glide,
which is pre-mounted on two sides of the Drawer (D), into the runner, which is pre-assembled on the Desk
Top (A). Push the Drawer (D) in until the lock stick of the glide on the Drawer (D) stays inside the runner
on the Desk Top (A). See Figure 2.
Note: To detach the Drawer (D) from the Desk Top (A). Pull the drawer until it's stopped by the lock stick.
Press down on the lock stick on the right side and lift up the left side of the Drawer (D), then pull out to
remove it. See figure 2.
B - Leg – 4 pcs
D - Drawer – 1 pc
F - Lock Washer – 8 pcs
I - Stopper – 2 pcs
www.pbteen.com
G - Nut – 8 pcs