Related Manuals for PB TEEN SOPHIE QUEEN BED
Summary of Contents for PB TEEN SOPHIE QUEEN BED
- Page 1 SOPHIE QUEEN BED ASSEMBLY INSTRUCTION Date: 2013-Aug.-17 Rev: www.pbteen.com Page 1 of 9...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS: • Please read all instructions carefully before assembling this bed. • For your safety, assembly by two or more adults is strongly recommended. • Keep these instructions for future use. • Use only vendor-supplied hardware to assembly this item. Using unauthorized hardware could jeopardize the structural integrity of the item. -
Page 3: Hardware Included
HARDWARE INCLUDED: (O) Flat Washer – 4x (L) Bolt M6x60mm – 4x (M) Bolt M6x38mm – 4x (N) Lock Washer – 8x (Q) Allen Key 4mm – 1x (R) Dowel 8x30mm – 8x (S) RH Screw 8x25mm – (P) Half Moon Washer – 4x TOOLS REQUIRED (NOT INCLUDED): ASSEMBLY INSTRUCTION STEPS: Put all furniture parts on a soft, scratch free surface such as a carpet or rug. - Page 4 Repeat steps # 2 - #4 to assemble the Right Headboard Post (F) to Headboard (A), as seen in the illustration below. Thread the 4 Bun Feet (H) into the pre-fixed insert nuts found under the Headboard and Footboard Posts (A&B) in a clock-wise direction until tight, as seen in the illustration below.
- Page 5 Determine the desired location of bed and then hold the assembled Headboard (A) in a vertical position- tilted slightly forward. 8. Attach each Side Rail (C) to the Headboard (A) by inserting the hook (pre-attached at the ends of the Side Rail) into the corresponding slots of the Left &...
- Page 6 11. Place the Slats Roll (D) onto the opening, in-between the Side Rails (C), as seen below. Make sure the ends of the slats rest upon the small ledge inside of the Side rails (C). 12. Thread the 3 Support Legs (K) into the pre-drilled holes on the Support Rail (J), as seen in the illustration below. Date: 2013-Aug.-17 Rev: www.pbteen.com...
- Page 7 Attach this assembled Support Rail (J) with Support Legs (K) to the underside of Slat Roll (D), as seen in the illustration below. NOTE: There are 3 possible positions for Support Rail (J). The center positions are used when using trundle. If using a trundle, please follow steps #13 - #15 to assemble the Support Rail (J) and Support Leg (K) to the pre-drilled holes on the opposite side of the bed to where you desire the trundle to be used.
- Page 8 17. Secure each Slat to the Side Rail (C) using 32 Round Head Screws (S) through the hole at the end of each slat and into the mattress support on the Side Rails (C), as seen in the illustration below. 18.
-
Page 9: Care Instructions
DOWN , as seen below. Attach the 4 Finials (I) on top of each leg of the Headboard (A) and Footboard (B) CARE INSTRUCTIONS: • Dust often using a clean, soft, dry, and lint-free cloth. • Blot spills immediately and wipe with a clean, damp cloth. •...
Need help?
Do you have a question about the SOPHIE QUEEN BED and is the answer not in the manual?
Questions and answers