Table of Contents
Advertisement
Chapter 7
Warning!
Changes to the IP address, subnet mask or gateway address are sent to
the unit when the Set button is clicked. However, they only take effect after
the unit is restarted!
– Click Set after entering a new IP address.
– Enter the old IP address in the address field of the Web browser and append
/reset to it (e.g. 192.168.0.1/reset). The VIP will be restarted after
which it can only be accessed at the new IP address.
Unit IP address:
Enter the desired IP address for the VIP in this field. The IP address must be valid
for the network.
Subnet mask:
Enter the subnet mask corresponding to the inserted IP address here.
Gateway IP address:
Enter the IP address of the gateway here if the unit is to establish a connection
to a unit that is in another subnet. Otherwise, this field can remain empty (0.0.0.0).
Video/audio transmission:
If the device is used in front of a firewall, TCP (HTTP port) should be selected as
the transmission protocol. For use in a local network, choose UDP.
Warning!
Multicast operation is possible only with the UDP protocol. The TCP
protocol does not support multicast connections.
Note
In UDP mode the MTU is 1514 bytes.
VIP 10
Configuring the Receiver
81
Advertisement
Table of Contents
