Table of Contents
Advertisement
Maintenance and Upgrades
can likewise result in the unit no longer being addressable, requiring it to be
replaced.
Note
After a reset, the unit can only be addressed via the factory default IP
address. The IP address can be changed as described in the chapter
entitled Installation (see page 22).
– If necessary, back up the current settings using the Download button on the
configuration page entitled Firmware and configuration upload (see page
66 for sender and page 83 for receiver).
– Use a pointed object to press the reset button which is found below the USB
interface (see page 16) until the „operating status" LED blinks red. All settings
will revert to their defaults.
– Change the IP address of the unit as necessary.
– Configure the unit to meet your requirements.
Repairs
Warning!
Never open the casing of the VIP device. The unit does not contain parts
that you can repair or replace.
Ensure that maintenance or repair work is performed only by qualified personnel,
or contact your VCS dealer service center.
Transfer and disposal
The VIP should only be passed on together with this manual.
The unit and its power supply contain environmentally hazardous materials that
must be disposed of according to law.
Defective or superfluous units and parts should be disposed of professionally or
taken to your local collection point for hazardous materials.
106
Chapter 12
VIP 10
Advertisement
Table of Contents
