Table of Contents
Advertisement
Configuring the Sender
Chapter 6
Video loss alarm:
Select On if the unit is to activate an alarm whenever the video signal is
interrupted.
Contrast alarm:
The VIP can trigger an alarm if the camera image shows too little contrast,
possibly indicating that the lens has been sprayed with paint or covered in some
way. Select On to enable this function.
Motion alarm:
Select On if the unit is to respond to a motion alarm.
Motion detection is configured on a separate page (see page 50).
Alarm input 1 ... Alarm input 2:
Select the option On in order to activate the alarm via the corresponding external
alarm sensor. Otherwise, select Off.
You can choose whether the alarm is triggered by an Active high (contact open)
or Active low (contact closed) input state.
Name:
You can enter a name for each alarm input, which is then displayed next to the
icon for the alarm input on the video live page during the respective configuration
(see page 63).
1./2. SNMP host address:
Enter the IP addresses of up to two chosen receivers here if the alarm message
is to be sent via SNMP-traps.
48
VIP 10
Advertisement
Table of Contents
