Table of Contents
Advertisement
Hardware Connections
Connection when an alarm signal is given
Sender and receiver can be configured to connect automatically with each other
when an alarm is triggered (see page 49 for sender and page 77for receiver).
After a short time, the live video image from the sender will be shown on the
connected monitor.
This option can also be used to connect two VCS units via an on-off switch at the
receiver. In this case, a computer is not needed to establish the connection (see
page 76).
Connection using a terminal program
This operating mode has various prerequisites. Refer to the section Setup using
terminal software (see page 21).
– Start the terminal program. Enter the command i to call up the IP menu.
– Enter the command r in the IP menu to change the remote IP address, then
enter the IP address of the device to connect to.
– Enter the command a in the IP menu to activate automatic connection set up.
Connection using a Web browser
This operating mode has various prerequisites. Refer to the section Establishing
the connection (see page 25).
– Use the Web browser to connect to the VIP receiver. Its home page will be
displayed.
– Establish the desired connection to the monitor (see page 97).
100
Chapter 10
VIP 10
Advertisement
Table of Contents
