Table of Contents
Advertisement
Chapter 7
Configuring the Receiver
Alarm sources
Both VIP decoder alarm inputs can be configured individually.
Alarm input 1 ... Alarm input 2:
Select the option On in order to activate the alarm via the corresponding external
alarm sensor. Otherwise, select Off.
You can choose whether the alarm is triggered by an Active high (contact open)
or Active low (contact closed) input state.
Name:
You can enter a name for each alarm input.
1./2. SNMP host address:
Enter the IP addresses of up to two chosen receivers here if the alarm message
is to be sent via SNMP-traps.
VIP 10
75
Advertisement
Table of Contents
