JVC XL-R5010BKC Instructions Manual page 25

6
Select and enter a track number (1-99) using
4 ¢
the (reverse) or
then press the SET button.
1. Select the track.
7
Repeat Steps 5 and 6 to program up to a
maximum of 32 steps.
• If you try to program over 32 steps, "MEMORY FULL" will be
shown in the information display, and the programming func-
tion ends automatically.
• Pressing the 7 (stop) button ends the programming function.
• Operation stops automatically when all of the programmed
tracks have been played.
8
Press the 3 button to start program play.
• Operation stops automatically when all the programmed tracks
have been played.
• During playback, the disc number, track number and play time
of the track are shown in the information display.
• The numbers of the tracks that have been played are cleared
from the music calendar. They are displayed again when pro-
grammed play is completed.
• Operation stops automatically (and "STOP" is shown in the
information display) when all programmed tracks have been
played.
3
• If the (play) button is pressed at a specific step in a program,
the programming function will end and playback will start from
Step 01, not the step currently shown in the information display.
(forward) buttons, and
SET
2. Enter the selection.
To clear a step (track) from the program
To remove a programmed track, while in the CD stop mode, press
the 4 (reverse skip) or ¢ (forward skip) buttons until the track
you want to erase is shown in the information display. Press the
CANCEL button to erase the track from the program. The step
number for each track following the one erased is automatically
reduced by one (i.e., steps are renumbered). To erase the entire pro-
gram, press the CANCEL button until "PG NO PROGRAM" is
shown in the information display.
To change the contents of the program
In the CD stop mode, press the SET button followed by the CAN-
CEL button. Programmed tracks will be erased in the reverse order
of when they were entered (starting from the last track pro-
grammed). Press the CANCEL button twice to erase one track.
Continue erasing in this manner until all of the tracks you wanted
to remove are erased. Enter new tracks into the program by follow-
ing programming Steps 5 and 6.
To check the contents of the program
To check the tracks you have entered into the program, press the 7
(stop) button, and use the 4 (reverse skip) or ¢ (forward skip)
buttons to review the programmed tracks. The program steps (PG
S**) and track numbers will be shown in the information display
one at a time as you toggle through the program (S: Step; **: step
number).
To return to continuous playback
In the CD stop mode, repeatedly press the PLAY MODE button on
the remote control until the total playing time is shown in the infor-
mation display.
Remote Control
PLAY
MODE
19