Inserting The Batteries; Using The Remote Control - JVC XL-R5010BKC Instructions Manual

Note
In this manual, procedures using buttons on the front panel of the
unit are depicted by the name of the button in capital letters with
the button illustration immediately after it. Procedures using the
buttons on the remote control are depicted by the button illustration
with the name of the button in small letters and parentheses imme-
diately after it.
CD Control PAUSE 8 button Front panel 8 (pause)
Example:
button Remote control

Inserting the Batteries

1
Press down on the point shown by the arrow at
the top of the compartment cover, and lift the
cover to open the compartment.
2
Place the two accompanying R6P(SUM-3)/
AA(15F) batteries in the remote control making
sure to match the battery polarities with the
markings ("+"/"–") inside the compartment.
3
Place the cover over the compartment and
press down lightly until it locks in place.

Using the Remote Control

STANDBY
STANDBY/ON
3 - CD
PHONES LEVEL
PLAY & EXCHANGE
MIN MAX
PLAY MODE CD EDIT CD REC
STOP PLAY PAUSE
PHONES
STANDBY/ON
CD1 CD2 CD3
CD REC CD EDIT FINALIZE DISPLAY
1 2 3
4 5 6
7 8 9
+10
10
PLAY C O N T R O L
MODE REPEAT CD CDR
•
REC FADE SYNCHRO
REC MUTING
+
PITCH
SET
PITCH–
RM–SXLR5010A
REMOTE CONTROL
• Point the remote control toward the left side of the front panel of
the main unit before you begin pressing buttons.
• The remote control can be operated at a distance of up to
approximately 7m (23ft) or so from the main unit. This distance
will be less if the remote control is operated from a position that
is not directly in front or on the same level as the main unit.
• When the distance over which the remote control can be oper-
ated starts to drop, it means that the batteries are nearing the end
of their service life.
• Replace both R6P(SUM-3)/AA(15F) batteries with new batter-
ies.
• The dry-cell batteries provided with the unit are for the purpose
of checking system operations only. Replace them with new
batteries as soon as possible.
• Do not drop the remote control or subject it to strong impact.
• In order to ensure that the remote control does not fail to oper-
ate, avoid the following conditions:
• Exposure of the main unit and remote control to direct sun-
light or other intense sources of light.
• Objects blocking the path of signals being transmitted from
the remote control to the main unit.
MULTI JOG
/REC LEVEL
– +
EJECT
DIGITAL CD LINE MIC REC SOURCE SELECTOR MIX BLANCE
LINE CD
MIC LINE
SYNCHRO MENU SET CANCEL
REC/
FINALIZE STOP PLAY PAUSE REC MUTING
MIC
9