Programming Playback Using Main Unit Controls - JVC XL-R5010BKC Instructions Manual

Programming Playback Using
Main Unit Controls
It is possible to select your own program (order of tracks being
played) using the program playback mode. Any of the tracks (1-99)
on the CDs in the trays of the 3-CD changer can be selected.
If you want to program and record tracks, see "Program Edit
Recording" on page 27.
1
STANDBY
STANDBY/ON
3 - CD
PHONES LEVEL
PLAY & EXCHANGE
MIN MAX
PLAY MODE CD EDIT CD REC
STOP PLAY PAUSE
PHONES
2 7
1
Load CDs into the trays of the 3-CD changer.
• Only tracks on the CDs loaded in the 3-CD changer can be reg-
istered into the program (i.e., tracks on a CD loaded in the CDR
cannot be selected for playback).
• "CD READ DISC" will be shown in the information display as
the unit reads the information from each disc.
Note
• To close a tray, press the 0 button for the tray number that is
open. If you press the 0 button for a tray number other than that
for the tray that is open, the program may not be played correctly.
2
Press the PLAY MODE button when the unit is
in the CD stop mode.
• The CD PLAYER indicator is shown in the display window,
PROGRAM indicator is shown in the display window, and if no
program has been registered, "PG NO PROGRAM" is shown in
the information display.
Program step
number
• If SET is pressed at this time, programming registration will
start (Step 3).
3
Press the SET button to start program
registration.
• The information display will show the following, and disc
source columns will flash.
Programming
step number
4,5
MULTI JOG
/REC LEVEL
– +
EJECT
DIGITAL CD LINE MIC REC SOURCE SELECTOR MIX BLANCE
LINE CD
MIC LINE
SYNCHRO MENU SET CANCEL
REC/
FINALIZE STOP PLAY PAUSE REC MUTING
MIC
3,4,5
Disc source
Track number
Disc source
Track number
4
Select the disc source (CD tray) by turning the
MULTI JOG control, and then press the SET but-
ton.
MULTI JOG
REC LEVEL
–
1. Select the disc.
= + = + =
CD1 CD2 CD3
• When the SET button is pressed, next the programming step and
track number columns will flash.
5
Select and enter a track number (1-99) by
turning the MULTI JOG control, and then press
the SET button.
MULTI JOG
REC LEVEL
–
1. Select the track.
• The following is an example of track 2 on the CD in tray CD1
being entered as Step 1.
• When the SET button is pressed, the programming of Step 1 is
registered, and programming for Step 2 is ready.
6
Repeat Steps 4 and 5 to program up to a
maximum of 32 steps.
• If you try to program over 32 steps, "MEMORY FULL" is
shown in the information display, and the programming func-
tion ends automatically.
• Pressing the CD Control STOP 7 button on the main unit ends
the programming function.
SET
+
2. Enter the selection.
+
SET
+
2. Enter the selection.
17