Adjusting The Projected Image - BenQ LW500 User Manual

Adjusting the projected image

Adjusting the projection angle
If the projector is not placed on a flat surface or the
screen and the projector are not perpendicular to
each other, the projected image becomes
trapezoidal. You can screw the adjuster feet to
fine-tune the horizontal angle.
To retract the feet, screw the adjuster feet in a
reverse direction.
Do not look into the lens while the light source is on. The strong light from the light source may cause damage to
your eyes.
Fine-tuning the image size and clarity
Adjust the projected image to the size that you
need using the zoom ring.
Correcting keystone
Keystoning refers to the situation where the projected image becomes a trapezoid due to angled
projection.
To correct this, besides adjusting the height of the projector, if you want the projector to automatically
correct image keystoning, be sure the Auto Vertical Keystone function in the Advanced Menu -
Display menu is On.
Or you will need to manually correct it following these steps.
1. Do one of the following steps to display the keystone correction page.
• Press / on the projector or remote control.
• Press QUICK INSTALL on the remote control. Press
Keystone and press OK.
• Go to Advanced Menu - Display > Keystone or 2D Keystone and press OK.
Sharpen the image by rotating the focus ring.
to highlight Keystone or 2D
Positioning your projector 17