Table of Contents
Advertisement
Blank Timer
Sets the image blank time when there is no action taken on the blank screen, once
elapsed the image will return to the screen. If the preset time spans are not suitable
for your need, select Disable. No matter Blank Timer is activated or not, you
can press most of the keys on the projector or remote control to restore the
picture.
Reminder Message
Sets the reminder messages on or off.
High Altitude Mode
We recommend you use the High Altitude Mode when your environment is
between 1500 m –3000 m above sea level, and ambient temperature is between
0°C–30°C.
Operation under "High Altitude Mode" may cause a higher decibel operating
noise level because of increased fan speed necessary to improve overall system
cooling and performance.
If you use this projector under other extreme conditions excluding the above, it
may display auto shut-down symptoms, which is designed to protect your projector
Operation
from over-heating. In cases like this, you should switch to High Altitude mode to
Settings
solve these symptoms. However, this is not to state that this projector can operate
under any and all harsh or extreme conditions.
Do not use the High Altitude Mode if your altitude is between 0 m and 1500 m and ambient
temperature is between 0°C and 35°C. The projector will be over cooled, if you turn the mode on
under such a condition.
Power On/Off Settings
• Direct Power On: Allows the projector to turn on automatically once the
power is fed through the power cord.
• Signal Power On: Sets whether to turn the projector directly on without
pressing
detects a VGA signal or a HDMI signal with 5V power.
• Auto Power Off: Allows the projector to turn off automatically if no input signal
is detected after a set period of time to prevent unnecessary waste of light source
life.
• Power Off Timer: Sets the auto-shutdown timer.
Security
See
Settings
Selects a baud rate that is identical with your computer's so that you can connect
Baud Rate
the projector using a suitable RS-232 cable and update or download the projector's
firmware. This function is intended for qualified service personnel.
Adjusts the equalizer gain settings for an HDMI signal. The higher the setting, the
HDMI
stronger the gain value. If there are more than one HDMI port on the projector,
Equalizer
select the HDMI port first before adjusting the value.
40
Menu operation
POWER or
Utilizing the password function on page
ON when the projector is in standby mode and
23.
Advertisement
Table of Contents
