• The brightness level of the projected image will change accordingly when you switch between different input
signals.
• For best display picture results, you should select and use an input signal which outputs at the projector's native
resolution. Any other resolutions will be scaled by the projector depending upon the "aspect ratio" setting,
which may cause some image distortion or loss of picture clarity. See
Shutting down the projector
1. Press
on the projector or
and a confirmation message will appear prompting you. If
you don't respond in a few seconds, the message will
disappear.
2. Press
or
flashes orange, the projection light source shuts down,
and the fans will continue to run for approximately 2
seconds to cool down the projector.
3. Once the cooling process finishes, the power indicator
becomes a steady orange and fans stop. Disconnect the
power cord from the power outlet.
To protect the light source, the projector will not respond to any commands during the cooling process.
on the remote control
a second time. The power indicator
Aspect Ratio on page
31.
Operation
25