PerkinElmer 200 Series User Manual page 54

4.2 For user accounts:
1) Now select the Job Types for the other users of the software.
Note: Steps 2 – 7 must be performed for all job types representing users
intending to use Series 200 Accessory Control Hands-On.
2) Select the 'Navigator Apps. Menu' button.
3) Select the 'New Document' icon and enter the following menu text: Series 200
Accessory Control Hands-On.
4) Next, as in step 7 of section 3.1, using the 'Folder' icon, select Hands-On.exe
5) On the 'Job Types' tab select the 'User Program Access' button.
6) Select this job type to have access to the following program: "PCcontrol.exe". (for
TotalChrom, enter the following Description: "Automated Series 200 Accessory
Control Program".)
7) Select File > Save and Reconfigure to save the configuration.
5. Series 200 Accessory Control Configuration
Note: For the Series 200 Accessory Controller, which incorporates both the
column oven and selector into a single hardware module, first configure the
oven as a "Series 200 Peltier Column Oven. Then, configure the column
selector as the stainless steel (SS) version of the Rheodyne 6-port Column
Selector.
If a formal IQOQ procedure is required, please refer to Section
Accessory Control IQOQ document.
After the Series 200 Accessory Control software has been installed, the following steps to
configure column oven/selector modules and customize manager access rights have to
be completed.
1) From the Windows, select Start > Programs > PerkinElmer > Series 200
Accessory Control > Series 200 Accessory Control Manager. (if this structure was
customized during installation, please follow customized structure.
Then, login to Series 200 Accessory Control Configuration Manager as a
"manager" with the default user name and password "manager" / "manager". From
the menu bar select Configuration > Manager Access to open the Manager
Access Configuration dialog. Select the 'Add' button to add user names and
passwords for users with administrative rights in Series 200 Accessory Control.
Select to delete the default manager login "manager".
2) Configure Communication Devices by selecting Configuration > Communication
and add communication devices.
3) Select Configuration > Accessory Wizard and run the Wizard to create
instruments and configure column ovens and column selectors.
Note: Only instruments that are configured in Turbochrom / TotalChrom can be
configured in Series 200 Accessory Control. Ensure that the Instrument Key
and Name match exactly (SysConfig > Instruments tab).
Please refer to the Series 200 Accessory Control Standard Operating Procedure,
Manager / Configuration Guide section for a detailed description of the
configuration procedure.
Page 6 of 6
III
of the Series 200