PerkinElmer 200 Series User Manual page 50

The following should be completed in conjunction with the Series 200
Accessory Control Installation Checklist :
2. Hardware Installation:
2.1 Column Oven
Install the column oven, including power cable (see Installation section in the
PerkinElmer Instruments Series 200 Peltier Column Oven (or Series 200 Accessory
Controller) User's Guide.
If the column oven is connected via a serial port on the local computer, install the RS-
232 modem cable supplied with the oven, connecting the oven to the computer.
If a Terminal Server is used to connect the column oven, install the corresponding
adapters and RJ12 cables to connect the module to the Terminal Server (see below).
2.2 Column Selector
Install the column selector, including power cable. (Not necessary if part of Series
200 Accessory Controller; proceed to next paragraph)
Important Note: In the following order, one should first power on the column
On the Series 200 Accessory Controller, the cable connection for the column selector
is made on the back of the unit.
If the column selector is connected via a serial port on the local computer, install the
Rheodyne RS-232 null-modem cable and adapter (see Requirements above)
connecting the oven to the computer. Install the inlet/outlet/column connections.
If a Terminal Server is used to connect the column selector, install the corresponding
adapters and RJ12 cables to connect the module to the Terminal Server (see next
page).
selector and then connect the RS-232 / Terminal Server cable. This
is especially important if the other end is already connected to
active computer port / Terminal Server.
Page 2 of 6