Table of Contents
Advertisement
2-4 Installing the Oven
Oven Power Cord and Fuses
The AC input power module is located on the left side of the back panel
and contains the on/off switch and system fuses.
Figure 2-1. Rear panel of the oven.
The unit is shipped with two 1.0 amp fuses installed for 230-Volt operation.
Prior to operation at 115 VAC, replace the fuses as described below.
To replace a fuse, proceed as follows (see Figure 2-1):
1. Turn off the AC power to the oven by pressing 0 on the On/Off switch (on
the rear of the oven). Then unplug the AC line cord from the AC outlet.
2. To remove a fuse, use a screwdriver to pry open the fuse holder. Install
2.0-amp fuses (P/N 0999-1637) in the fuse holder (for 115-Volt operation)
and reinsert the fuse holder in the power entry module.
3. Make certain that the Voltage Selector switch is in the position required.
(Here??)
Electrical Requirements and Settings
Advertisement
Table of Contents
