PerkinElmer 200 Series User Manual page 52

3. Software Installation
3.1 Server Application (Server and Client Application)
1) It is recommended that one install the server application on the same computer on
which the Turbochrom / TotalChrom (TC) Server is installed.
In the Series 200 Accessory Control Configuration Checklist, enter the name of
the server on which Series 200 Accessory Control server application will be
installed. The Configuration Checklist is located on the installation CD or in
section III of the Appendix within the Series 200 Accessory Control IQOQ.
Note: On a Client/Server system, install the server application once, on only one
computer.
2) To install the Series 200 Accessory Control software log on as a Windows
administrator.
3) Run the Setup.EXE on the installation CD.
4) Follow the instructions on the Welcome screen.
5) On the Installation Type screen select to install the "Server and Client
Applications".
Note: To install the Server component, Windows NT 4 (Service Pack 5) or higher
is required.
6) On the Server Account screen enter the "Domain\Account". This should refer to the
Turbochrom / TotalChrom TCProcess account which must have administrative rights.
Enter the account's password and password confirmation.
7) On the Destination Location screen the following default directory is selected:
"C:\Program Files\PerkinElmer\Series 200 Accessory Control" or select the
"Browse" button to select another destination folder.
8) On the Backup Replaced Files screen it is recommended to create backups of
replaced files. By default the following directory is selected:
"C:\Program Files\PerkinElmer\Series 200 Accessory Control\BACKUP".
If in the previous dialog (step 7) another destination folder has been selected, the
BACKUP folder will be created in the appropriate destination folder.
9) On the Select Program Manager Group screen a program manager group is
entered by default (PerkinElmer\Series 200 Accessory Control). If desired enter
another program manager group.
Note: With the selected program manager group, on NT any user has access to
this program.
10) On the Start Installation screen select "Next" to install the program.
11) The program will be installed.
Note: During installation a computer restart might be required if newer system
components have to be installed.
After the restart, the same login has to be used.
After the computer restart, the installation process will start from the
beginning. Reenter the original entries.
12) When the Installation Complete screen appears the installation is finished.
Selecting the "Finish" button will complete the Installation program.
13) After the installation, the system has to be restarted. If an immediate restart is
desired, select "OK" in the Install dialog or select "Cancel" to return to Windows
and restart the system later.
Page 4 of 6