Table of Contents
Advertisement
2.3 Terminal Server
Connect the Terminal Server to the network and configure the Terminal Server (see
Lantronix Terminal Server Installation Guide).
It is encouraged to check Terminal Server port parameters for Series 200 Accessory
Control. These parameters can be accessed by Telnetting to the terminal server and
typing "show ports x", "x" being the port number to which the device is connected.
The parameters should be set as follows:
Char Size/Stop Bits:
Flow Ctrl:
Parity:
Access:
Backward:
Break Ctrl:
Forward:
Preferred Services:
Authorized Groups:
(Current) Groups:
Characteristics:
2.5 General
Ensure that the relevant computers, the terminal server, if available, the column oven
and column selector, interfacing hardware, the HPLC system, and the printer are
turned on.
8/1
None
None
Remote
None
Local
None
(Lat)
(Telnet)
0
0
Loss Notify Remote Conf
Input Speed:
Output Speed:
Modem Control:
Local Switch:
Port Name:
Session Limit:
Terminal Type:
Page 3 of 6
9600
9600
None
None
Port_1
4
Soft()
Advertisement
Table of Contents
