Table of Contents
Advertisement
Series 200 Accessory Control
1. Requirements
1.1 Software Requirements
•
PerkinElmer Series 200 Accessory Control software
•
PerkinElmer Turbochrom 6.1.2 or TotalChrom 6.2 Workstation (WS) or
Client/Server (CS) software
1.2 Hardware Requirements
•
PerkinElmer Series 200 Peltier Column Oven (Part number: N260-1580) or Series
200 Accessory Controller
•
Rheodyne LabPRO 6-Column Selector
Rheodyne Part numbers: PR501-104-01 (Stainless Steel) or PR551-104-01
(PEEK); previously purchased as "Special" through PerkinElmer
1.3 Terminal Server Connection
If a Terminal Server is used to connect the modules the following hardware is required:
•
8-port Lantronix Terminal Server: Part number S200-0062;
Note: The older terminal servers require a Transceiver, Part number S200-0009
•
Corresponding adapter(s) supplied in Series 200 Accessory Control Kit.
•
An RJ12 cable for each module.
Part numbers:
•
An RJ45 cable to connect the Terminal Server to the network.
Contact Lantronix for available cables.
1.4 Serial Port Connection
If the modules are connected via the computer's serial ports the following hardware is
required:
•
9-pin Com (serial) port(s) must be available on the computer.
•
A RS-232 modem cable (25-pin male to 9-pin female) for each oven; supplied with
each column oven
•
A Null-modem 25-pin RS-232 cable (Rheodyne part number 5123-067) for each
column selector; purchased as "Special" through PerkinElmer.
•
For column selector: Standard 9-pin computer serial ports require 25-pin (male) to
9-pin (female) converter – from any computer store
Installation Guide
7ft. / 2m:
S501-0037
25ft. / 7m:
S501-0038
50ft. / 15m:
S501-0039
100ft. / 30m: S501-0040.
Page 1 of 6
Advertisement
Table of Contents
