Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for sauter SD Series
Summary of Contents for sauter SD Series
- Page 1 Sauter GmbH Ziegelei 1 Phone : +49-[0]7433- 9933-0 D-72336 Balingen Fax: +49-[0]7433-9933-149 e-mail: info@kern-sohn.com Internet: www.sauter.eu Instruction manual spring testing system SAUTER SD Version 2.1 11/2021 PROFESSIONAL MEASURING SD-BA-e-2121...
-
Page 2: Table Of Contents
V. 2.1 11/2021 Instruction manual spring testing system Congratulations on your purchase of the SAUTER SD spring test bench. We hope you enjoy your quality measurement system with its wide range of functions and high reproducibility. If operated correctly, this high-quality product will give you many years of use. -
Page 3: Scope Of Delivery
After receipt of the test stand, it should be checked in advance whether no transport damage has occurred, whether the outer packaging, the metal housing, other parts or even the test stand itself have been damaged. If any damage is evident, please notify SAUTER GmbH immediately. 3 Technical data Test bench... -
Page 4: Operation
4 Operation 4.1 Display (1) Measurement result (2) Display unit of the measurement result (3) PEAK indicates that peak hold mode is activated AUTO PEAK keeps the peak value in the display only for a defined time (see 2.4) (4) Display of the direction of force (5) Assignment of the memory locations (6) Average value or individual peak value 4.2 Control keys... - Page 5 SET: Press once: Upper limit [HidT]. Press to change it: ▲ or ▼ (see 2.3) Hi dT Press once: Lower limit value [LodT]. Press to change it: ▲ or ▼(see 2.3) Lo dT Press once: Lower limit value to activate the memory function at Peak value measurements (peak).
-
Page 6: Limit Value Display Good / Bad
DELETE FUNCTION: of memory values (only in "Memory" mode) PRINT: (print function) Output of the memory contents to PC or printer (see section 7.) 4.3 Limit value display good / bad ▲ HI Exceeding the upper limit value ( LED lights up red ) ◘... -
Page 7: Storage Of Peak Values And Calculation Of Average Values From Up To 10 Values
This function is used for measurements where unwanted "pre-peaks" occur which are below the peak value (Fp) being searched for. The adjustable limit value (Fo) prevents the measuring instrument from storing the "pre-peaks". Minimum limit function is only possible in "Peak Mode Setting the minimum limit value function see SET menu under "Keys 4.8 Storage of peak values and calculation of average values from up to 10 values... - Page 8 narrow guide slot during printing. On the right side of this tray is a small button which must be pressed to open it, e.g. when a new paper roll has to be inserted. The next figure shows the open paper tray. It shows how to correctly load the paper roll in the paper roll compartment to make subsequent prints.
-
Page 9: General Safety Instructions
7 General safety instructions WARNING Risk of injury due to overridden functions of the protective devices! Overloaded functions of the protective devices can lead to severe Injuries lead. ● Never override the functions of the protective devices, either yourself or by third parties. ●... - Page 10 WARNING Risk of injury from electric shock! There is a risk of injury when cleaning the electrical system with wet cloths. by electric shock. ● Turn off the power supply with the main switch. ● Unplug the power cord. ● Do not use wet cleaning cloths. ●...
Need help?
Do you have a question about the SD Series and is the answer not in the manual?
Questions and answers