Table of Contents
Advertisement
Setup
Power Connection
Electricity can be supplied to this product either
by using the PoE or connecting to the DC 12 V
power supply.
When electricity is supplied to the camera,
the status indicator blinks, and turns off when
startup is complete.
Note ：
● Make sure to select only one mode of
electrical supply. Connecting the power cable
and the LAN cable for the PoE at the same
time may result in failure or malfunction of the
camera.
Using the PoE
Connect to a device that supports PoE and
supply electricity from the LAN cable.
What is PoE (Power over Ethernet)?
This is a function that enables operation of a
LAN equipment without a power cable by
supplying power simultaneously with the data
using a LAN cable.
Memo ：
● For details on the connection method and
cable type, please refer to LAN Cable
Connection (A Pg. 26).
24
Connect to PoE-
compatible device
10BASE-T/
100BASE-
TX(PoE)
terminal
LAN cable
Connecting to the DC12 V power supply
Connect this product to the DC12 V power
supply when not using the PoE.
Connect the polarity correctly.
Red
: DC12 V+
Black
: DC12 V-
Note ：
● Make sure to select only one mode of
electrical supply. Connecting the power cable
and the LAN cable for the PoE at the same
time may result in failure or malfunction of the
camera.
LAN cable
Wind the
waterproof
tape
Memo ：
About the power cable
● When using 2-core VVF (Vinyl-insulated
vinyl-sheath cable), the connection distance
is as follows: (Reference value)
Maximum
90 m
extension
(300 ft)
R1.0 and
Conductor
Diameter
above
(mm)
Base
Power cable
Black:
Red:
DC12 V-
DC12 V+
Solder or
crimp
Insulation tape
Heater power cable
(White, Gray)
240 m
390 m
(790 ft)
(1280 ft)
R1.6 and
R2.0 and
above
above
Advertisement
Table of Contents
