Holder ribbon cable
Screw
(4 places)
Disconnecting the CK61 Holder Cables: In addition to the ribbon cable, the CK61
holder (shown above) may also have a ground cable attached at Location 1 or
Location 2.
5 Tilt the printer mechanism back into place.
6 Remove the four flathead screws that secure the existing
7 Lift the holder from the printer. The holder is still connected
8 Disconnect the ground cable and carefully pull the ribbon
6820 Series 80-Column Printer Terminal Holder Installation Instructions
To printer mechanism
Printer mechanism
removed for clarity
holder to the printer.
to the printer by a ground cable.
cable out from under the printer mechanism. You may need
to lift the mechanism out of the way.
CK61 holder only
Location 2
Location 1
9