Intermec 6820 Series Installation Instructions Manual page 16

7 Insert the metal connector on the end of the printer ground
8 If you are replacing an older CK61 holder, connect the new
9 If you are installing a Bluetooth-enabled holder, place the
To install cables in a fixed printer
1 Position the holder near the mounting bay. The connector
2 For the 700, CK61, and CN70/CN70e holders, continue
16 6820 Series 80-Column Printer Terminal Holder Installation Instructions
cable into the connector on the holder ground wire. Make
sure the connectors are fully seated.
holder ground cable to either of the printer ground cables.
new FCC label over the existing FCC label inside of the
printer case. The new label indicates that related parameters
have changed.
end of the holder should be closer to the 6820 front panel
buttons.
with the next step.
For the CN3/CN3e or CN4/CN4e holder, route the cables
through the bottom of the adapter (P/N 642-850-001) and
place the holder in the adapter.
Screw
(4 places)
Connector end
of holder
Adapter
(CN3/CN4 only)