Tools Required; Installing The Holder; Removing The Existing Holder - Intermec 6820 Series Installation Instructions Manual

The Bluetooth-enabled holder in this kit must be installed by
a qualified technician. The hardware in this kit is warranted
for 1 year. If the hardware is installed by non-Intermec-
authorized service personnel and there is a hardware failure,
at Intermec's sole discretion, if the cause of this failure is
determined to be related to improper installation of the
Bluetooth-enabled holder, any warranty periods remaining
for any components of the kit will be voided. Any costs
associated with the remediation of such failures will be the
responsibility of the user.

Tools Required

You need these tools to install the holder in the printer:
•
•

Installing the Holder

To install the holder, you need to follow the steps below. These
steps are explained in the next sections.
1 Remove the existing holder.
2 Install the cables for the new holder.
3 Install the new holder.
4 Insert the computer in the holder.
5 Configure the printer to communicate with your computer.

Removing the Existing Holder

The steps for removing the holder are different depending on
whether the 6820 printer is fixed or portable:
•
•
To remove the existing holder from a portable printer
1 Disconnect external power and remove the internal battery
2 Open the printer lid.
6820 Series 80-Column Printer Terminal Holder Installation Instructions
#1 Phillips screwdriver
#0 Phillips screwdriver
For a portable printer, see the next procedure.
For a fixed printer, see
from a fixed printer" on page
(if installed) from the printer.
"To remove the existing holder
10.
7