Intermec 6820 Series Installation Instructions Manual page 17

3 Route the ribbon cable into the printer through the slot in
4 Connect the cable to the ribbon cable extender and lock the
5 Connect the holder ground cable to the printer ground cable.
6 If you are replacing an older CK61 holder, connect the new
7 Inside the printer cable area, place the access cover standoffs
8 For the CN70/CN70e holders, install the ESD cover.
6820 Series 80-Column Printer Terminal Holder Installation Instructions
the side of the case.
connectors.
Make sure the connector is fully seated.
holder ground cable to either one of the existing extender
cables. Route the extra cable back into the printer and place it
into the empty area outside the paper tray.
over the screw holes and replace the printer access cover.
a Turn the printer over.
b Remove the protective film from the ESD cover to expose
the adhesive.
c Angle the ESD cover onto the holder and press firmly.
17