E.g. Event Control - Omron STC-MBA503POE Product Specifications And User's Manual

10.18 Event Control
The camera internal signal can be output as specified event information, like "exposure end", to PC used by
GVCP (GigE Vision Control Protocol).

e.g. Event control

Notified "Exposure End"
Exposure Line 1
Exposure Line 2
Exposure Line 3
Exposure Line N-1
Exposure Line N
Exposure Active
Sensor Read Out
GenICam Parameters
Event Selector
Event Notification
STC-MBA503POE / STC-MCA503POE
Product Specifications and User's Guide
GVCP
Event Exposure Start
Event Frame Start
IEnumeration Type Event notification selection
Selection: "Action Late", "Frame Trigger", "Exposure Start", "Exposure End",
IEnumeration Type Event notification ON / OFF selection
On: Enable event notification
Off: Disable event notification
Event Exposure End
"Frame Start", "Frame End", "Block Discard",
"Line 0 Input Rising Edge", "Line 0 Input Falling Edge",
"Line 2 Input Rising Edge" and "Line 2 Input Falling Edge"
No.19S182-01
Event Frame End
55/73